Sir Coil Assembly: Installation
NOTE:
New SIR coil assemblies have Yellow plastic tab to prevent rotation. Do not remove this tab until after installation. If tab is not present, tape centered SIR coil assembly.
CAUTION:
If off-centered coil assembly is installed, ribbon in coil assembly will break when steering wheel is turned.
Ensure SIR coil assembly to be installed is properly centered. See SIR COIL ASSEMBLY under ADJUSTMENTS. Route SIR coil assembly wiring harness through rectangular slot below steering column. Position SIR coil assembly. On 2000 models, install retaining screws. On 2001 models, push to install plastic retainer tabs. On all models, to complete installation, reverse remainder of removal procedure.