Diagnostic Procedures
- Turn ignition on, with engine off. Using scan tool, command EVAP solenoid on and monitor EVAP VENT - HIGH VOLT test. If scan tool indicates TEST FAIL, go to next step. If scan tool does not indicate TEST FAIL, problem is intermittent. See DIAGNOSTIC AIDS .
- Raise vehicle to about chest height. Remove left rear inner fender well. Disconnect EVAP vent solenoid harness connector. Connect a Noid Light (SA9194E) to EVAP vent solenoid harness connector. Using scan tool, command EVAP vent solenoid on and monitor EVAP VENT - HIGH VOLT test. If scan tool does not indicate TEST PASS, go to next step. If scan tool indicates TEST PASS, replace EVAP vent solenoid.
- Check for short to voltage in EVAP vent solenoid circuit (White wire) to PCM. Repair as necessary. If circuit is okay, replace PCM.