LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2003 >> Ion 1 Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System & Component Testing >> Emission Systems & Sub-Systems >> Evaporative Emission System Cleaning >> Cleaning Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Cleaning Procedure

  1. Raise and support vehicle.
  2. Disconnect the EVAP canister vent solenoid valve harness connector.
  3. Disconnect the EVAP canister hose connections.
  4. Remove the EVAP canister retaining bolt. Remove the EVAP canister assembly toward the outboard side of the vehicle.
  5. Turn OFF the main valve on the EVAP pressure/purge diagnostic station.
  6. Disconnect the hose from the diagnostic station pressure regulator.
  7. Using a section of vacuum hose, connect one end onto the diagnostic station pressure regulator.
  8. Connect the other end of the vacuum hose to the canister side of the purge pipe.
  9. Turn ON the main nitrogen cylinder valve and continue to discharge nitrogen for 15 seconds.
  10. If the nitrogen does not dislodge the carbon particles, replace the purge pipe.
  11. Return the EVAP pressure/purge diagnostic station to the original condition of the station.
  12. Install a new EVAP canister.
  13. Lower the vehicle.
  14. Install a new EVAP canister purge valve.
  15. Return to the diagnostic procedure that sent you here.
scientia non olet · About LEMON Manuals