Particulate Contaminants In Fuel Testing Procedure

The fuel sample should be drawn from the bottom of the tank so that any water present in the tank will be detected. The sample should be bright and clear. If the sample appears cloudy, or contaminated with water, as indicated by a water layer at the bottom of the sample, use the following procedure to diagnose the fuel.

1. Using an approved fuel container, draw about 0.13 gal. (0.5 L) of fuel.
2. Place the cylinder on a level surface for about 5 minutes in order to allow settling of the particulate contamination.

Particulate contamination will show up in various shapes and colors. Sand will typically be identified by White or Light Brown crystals. Rubber will appear as Black and irregular particles. If particles are found clean the entire fuel system thoroughly. See FUEL SYSTEM CLEANING under FUEL SYSTEMS in REMOVAL & INSTALLATION - SATURN "L" SERIES article.