Removal Procedure

Disable the SIR System. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in Air Bag Restraint Systems.

Fig 1: Removing & Installing Shift Control Cable From Control Assembly
Courtesy of GENERAL MOTORS CORP.
Remove the console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
Using a screwdriver, disconnect the control cable end from the pin on the control assembly.
Remove the control cable retaining clip.
Press the tabs on the control cable and remove the cable from the control assembly.
Disconnect the control assembly electrical connectors.

Fig 2: Removing & Installing Shift Lock Control Assembly Electrical Connectors
Courtesy of GENERAL MOTORS CORP.
Remove the control assembly-to-floor pan bolts and remove the control assembly.

Fig 3: Removing & Installing Shift Control Assembly

Courtesy of GENERAL MOTORS CORP.

If the shifter control assembly is being replaced, transfer the parts as needed. Refer to the appropriate procedures in this service manual.