LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2004 >> Ion 1 Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Introduction) >> Repair Instructions >> Ignition Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    IMPORTANT: Make sure the interconnect and seal are lined up before module installation.
  1. Install the ignition control module in the ignition coil housing.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the ICM retaining screws.

    Tighten:  Tighten the retaining screws to 1.5 N.m (13 lb in).

  3. Connect the ICM harness connector.
    4. Fig 1: View Of ICM
    GM783965Courtesy of GENERAL MOTORS CORP.
  4. Install the accelerator cable bracket.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the accelerator cable bracket bolt.

    Tighten:  Tighten the retaining screws to 10 N.m (18 lb in).

  6. Install the accelerator cable to the bracket.
scientia non olet · About LEMON Manuals