Installation Procedure
CAUTION:
Refer to Gasoline/Gasoline Vapors Caution
in Cautions and Notices.
NOTE:
Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:
- The fuel pipe connections
- The hose connections
- The areas surrounding the connections
- Remove the cap from the fuel pressure service port connection.
- Remove the engine identification cover nuts and cover.
- Connect the SA9127E , or the J 34730-1A to the fuel pressure service connection. See Special Tools and Equipment . Wrap a shop towel around the fitting while connecting the gage to avoid spillage.
- Turn the ignition ON, with the engine OFF.
- Place the bleed hose of the SA9127E , or the J 34730-1A into an approved fuel container. See Special Tools and Equipment .
- Open the bleed valve on the SA9127E , or the J 34730-1A in order to bleed the air from the fuel pressure gage.
- Command the fuel pump ON with a scan tool.
- Close the bleed valve on the SA9127E , or the J 34730-1A .
- Inspect for fuel leaks.
CAUTION:
Wrap a shop towel around the fuel pressure connection in order to reduce the risk of fire and personal injury. The towel will absorb any fuel leakage that occurs during the connection of the fuel pressure gage. Place the towel in an approved container when the connection of the fuel pressure gage is complete.
CAUTION:
Do not drain the fuel into an open container. Never store the fuel in an open container due to the possibility of a fire or an explosion.