LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Ion 1 Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Introduction >> Repair Instructions >> Fuel Hose/Pipes Replacement - Engine Compartment >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the fuel feed pipe to the fuel rail.

    Tighten:  Using a backup wrench on the fuel rail tighten the fuel feed pipe to 10 N.m (89 lb in).

    2. Fig 1: Connecting/Disconnecting Fuel Feed Pipe
    GM854303Courtesy of GENERAL MOTORS CORP.
  2. Install the engine fuel feed pipe fastener located on the engine.

    Tighten:  Tighten the fuel feed pipe fastener to 10 N.m (89 lb in).

    3. Fig 2: View Of Fuel Feed Pipe Fastener
    GM854304Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine fuel feed pipe to the chassis fuel flex hose. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  5. Inspect for leaks using the following procedure:
    1. With the engine OFF, turn ON the ignition for 2 seconds.
    2. Inspect for fuel leaks.
    3. Turn the ignition OFF.
    4. With the engine OFF, turn ON the ignition for 2 seconds.
    5. Inspect for fuel leaks.
    6. Turn the ignition OFF.
scientia non olet · About LEMON Manuals