LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Ion Red Line >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Introduction >> Repair Instructions >> Heated Oxygen Sensor Replacement - Position 2 >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the wheel drive shaft heat shield. Refer to Wheel Drive Shaft Heat Shield Replacement in Engine Exhaust.
  3. Note the routing of the heated oxygen sensor (HO2S) electrical harness.
  4. Disconnect the HO2S electrical connector (2), in the engine compartment.
    5. Fig 1: View Of HO2S & Electrical Connector
    GM1389438Courtesy of GENERAL MOTORS CORP.
  5. Carefully bend the edge of the channel on the LH side of the exhaust heat shield outboard, just enough to release the HO2S electrical harness (1).
    6. Fig 2: Locating HO2S Electrical Harness
    GM889722Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Heated Oxygen and Oxygen Sensor Notice in Cautions and Notices.
    NOTE: Refer to Excessive Force and Oxygen Sensor Notice in Cautions and Notices.
  6. Using the J 39194, carefully remove the HO2S.
  7. Lower the HO2S electrical harness away from the underbody.
scientia non olet · About LEMON Manuals