Scan Tool Data List
IMPORTANT:
Not all listed data parameters are available on all vehicles.
Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine ON/Steering wheel centered/No force applied to steering wheel | |||
| Actual Motor Current | Data Display and EPS Data List 2 | Amps | 0.0 |
| Battery Voltage | Data Display and EPS Data List 1 | Volts | 14.3 |
| Desired Motor Current | Data Display and EPS Data List 2 | Amps | 0.0 |
| Ignition Cycles Since Last Code Set | EPS Data List 2 | Numeric | 0 |
| Ignition Voltage | Data Display and EPS Data List 1 | Volts | 14.3 |
| Limiting Motor Current | Data Display | Amps | 58 amps |
| Lowest Limiting Current | EPS Data List 2 | Amps | 58 amps |
| Motor Voltage + | Data Display and EPS Data List 1 | Volts | 0.0 |
| Motor Voltage - | Data Display and EPS Data List 1 | Volts | 0.0 |
| Overload Protection Incidents | EPS Data List 2 | Numeric | 0 |
| Steering Calibration | EPS Data List 1 | Numeric 1-8 | Varies |
| Steering Shaft Torque | EPS Data List 2 | N.m or lb ft | 0.00 |
| Torque Sensor Amplified | Data Display | N.m or lb ft | 0.00 |
| Torque Sensor Main | Data Display | N.m or lb ft | 0.00 |
| Torque Sensor Sub | Data Display | N.m or lb ft | 0.00 |
| Tuning Profile | Data Display | Numeric 1-8 | Varies |
| Vehicle Speed | Data Display and EPS Data List 1 | km/h or mph | 0 |
| 9-11 Volt Battery Occurrences | EPS Data List 2 | Numeric | 0 |