LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Ion Red Line >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Gear Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the steering gear to the frame through the LH wheel opening.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the steering gear bolts.

    Tighten:  Tighten the bolts to 110 N.m (81 lb ft).

    3. Fig 1: View Of Steering Gear Bolts
    GM851710Courtesy of GENERAL MOTORS CORP.
  3. Connect the intermediate shaft to the steering gear.
  4. Install a new intermediate shaft pinch bolt.

    Tighten:  Tighten the bolts to 34 N.m (25 lb ft).

    5. Fig 2: View Of Intermediate Shaft-To-Steering Gear Pinch Bolt
    GM851655Courtesy of GENERAL MOTORS CORP.
  5. Install the outer tie rods to the steering knuckles.
    6. Fig 3: View Of Tie Rod End To Steering Knuckle
    GM854972Courtesy of GENERAL MOTORS CORP.
  6. Install new outer tie rod nuts.

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

  7. Install the front wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
  9. Adjust the toe if necessary. Refer to Front Toe Adjustment in Wheel Alignment.
scientia non olet · About LEMON Manuals