Installation Procedure

Fig 1: Oiling Male Pipe Ends (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

CAUTION: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.

Apply a few drops of clean engine oil to the male pipe end.

Fig 2: Assembling Connectors (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

Push both sides of the fitting together to cause the retaining tabs to snap into place.

Fig 3: Ensuring Connection (Metal Collar) Is Secure

Courtesy of GENERAL MOTORS CORP.

Once installed, pull on both sides of the fitting to make sure the connection is secure.
Install the retainer to the quick-connect fitting, if applicable.