Test Description
The number below refers to the step number on the diagnostic table.
- 6: This step tests if the instrument panel cluster (IPC) is able to turn ON the Traction Off indicator.
Traction Off Indicator Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: ABS Schematics Connector End View Reference: ABS Connector End Views or Instrument Panel, Gages, and Console Connector End Views in Instrument Panel, Gages, and Console |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
Go to Diagnostic Aids | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Step 5 |
| 4 | Replace the TCS switch. Refer to Traction Control Switch Replacement . Did you complete the replacement? |
Go to Step 9 | - |
| 5 | Test for an open in the TCS switch signal circuit. Refer to Circuit Testing
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 6 |
| 6 |
|
Go to Step 8 | Go to Step 7 |
| 7 | Replace the IPC. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 9 | - |
| 8 | Replace the body control module (BCM). Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 9 | - |
| 9 |
|
System OK | Go to Step 2 |