LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> Brakes >> Antilock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    IMPORTANT: Use only new wave springs and screws supplied with the new EBCM.
    Fig 1: Separating/Installing EBCM From BPMV
    GM255233Courtesy of GENERAL MOTORS CORP.
  1. Clean the BPMV surface with alcohol using a clean rag.
  2. Install the EBCM (1) to the BPMV.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 6 screws that attaches the EBCM to BPMV.

    Tighten: 

    • Tighten the top 4 mounting screws to 5 N.m (44 lb in). Tighten screws in an X pattern.
    • Tighten the bottom 2 mounting screws to 5 N.m (44 lb in).

  4. Connect the pump motor connector to the bottom of the EBCM.
    5. Fig 2: Identifying Electronic Brake Control Module
    GM1544732Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical harness connector (2) to the EBCM.
  6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.5L.
  7. Turn the ignition switch to the RUN position, do not start engine.
  8. Perform the diagnostic system check. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals