LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Relay FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.5L - Introduction (2 Of 2) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Lubricate the O-ring with clean engine oil before installation and replace the O-ring if necessary.
    2. Fig 1: View Of CKP Sensor (7X)
    GM15969Courtesy of GENERAL MOTORS CORP.
  2. Install the CKP sensor.
    3. NOTE: Refer to Fastener Notice .
  3. Install the CKP sensor bolt.

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

  4. Connect the CKP sensor electrical connector.
  5. Connect the block heater electrical connector, if equipped.
  6. Connect the catalytic converter. Refer to Exhaust Seal Replacement in Engine Exhaust.
  7. Lower the vehicle.
  8. Perform the CKP system variation learn procedure. Refer to CKP System Variation Learn Procedure .
scientia non olet · About LEMON Manuals