LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Vue Red Line, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.5L (L66) Introduction >> Repair Instructions >> Idle Learn Procedure >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Idle Learn Procedure: Notes

  1. Install a scan tool.
  2. Diagnose and repair any DTCs before proceeding with this procedure. Refer to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information for the applicable DTC that set.
  3. Ensure that all electrical loads and accessories are OFF.
  4. Turn OFF the air conditioning.
  5. Ensure that the vehicle is in PARK or NEUTRAL.
  6. Turn ON the ignition.
  7. Clear the DTC information with the scan tool.
  8. Wait 5 seconds and start the engine.
  9. Operate the engine with no load at 3,000 RPM until the ECT reaches 90°C (194°F).
    10. IMPORTANT: If the engine cooling fan turns ON during the idle portion of this procedure, do not include the fan run time in the total idle time.
  10. Let the engine idle with the THROTTLE CLOSED and the engine cooling fan OFF, for a total of 5 minutes.
  11. The PCM has a new learned idle position.
  12. The idle learn procedure is required when the following service procedures have been performed:
    • The throttle body assembly is replaced
    • The throttle valve is cleaned-Deposits can build up in the throttle body requiring periodic cleaning of the throttle valve and throttle bore area. Refer to Throttle Body Service  .
    • The Clear DTCs function has been performed
    • The PCM has been programmed.
    • The PCM is replaced
scientia non olet · About LEMON Manuals