Circuit/System Testing
NOTE:
Refer to Three-Way Catalytic Converter Damage Notice
.
NOTE:
Refer to Heated Oxygen Sensor (HO2S) Resistance Learn Reset Notice
.
IMPORTANT:
A new converter with less than 100 miles on it may set P0420 due to out-gassing of the internal matting. Operating the vehicle at highway speeds for approximately 1 hour may correct the condition.
- Inspect the catalytic converter for the following conditions:
- Dents
- A severe discoloration caused by excessive temperatures
- Road damage
- An internal rattle caused by damaged catalyst substrate
- Restrictions
- If a condition is found, replace the catalytic converter.
- Inspect the exhaust system for the following conditions:
- Leaks
- Physical damage
- Loose or missing hardware
- Properly torqued HO2S
- If a condition is found, repair the exhaust system.
- Inspect the HO2S 2 for the following conditions:
- A grounded wiring harness
- Damage
- If a condition is found, replace the HO2S 2.
- If no physical condition is detected, replace the catalytic converter.