Test Description

The number below refers to the step number on the diagnostic table.

2: This test determines whether the engine can achieve the commanded RPM. If the engine does not reach the commanded RPM, the test determines whether the RPM is too high or too low.

DTC P0506

Step	Action	Yes	No
Schematic Reference: Engine Controls Schematics Connector End View Reference: Engine Controls Connector End Views or Powertrain Control Module (PCM) Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Start the engine. Command the engine speed up to 1,500 RPM, down to 500 RPM, and up to 1,500 RPM with a scan tool. Exit the RPM control function. Does the engine speed correspond, within 100 RPM, with each command?	Go to Testing for Intermittent Conditions and Poor Connections	Go to Step 3
3	Inspect for any condition that can reduce idle speed by increasing engine load. Examples include: Incorrect torque converter clutch (TCC) operation Accessories that require additional torque to operate Restricted exhaust Mechanical conditions that limit engine speed Did you complete the action?	Go to Step 4	-
4	Clear the DTCs with a scan tool. Turn OFF the ignition for 30 seconds. Start the engine. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records. Did the DTC fail this ignition?	Go to Step 2	Go to Step 5
5	Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed?	Go to Diagnostic Trouble Code (DTC) List - Vehicle	System OK