Test Description

The number below refers to the step number on the diagnostic table.

8: More than one ETC system related DTC may set. This is due to the many redundant tests run continuously on this system. Locating and repairing one individual condition may correct more than one DTC. Keep this in mind when reviewing captured DTC info.

DTC P2119

Step	Action	Values	Yes	No
Schematic Reference: Engine Controls Schematics Connector End View Reference: Engine Controls Connector End Views or Powertrain Control Module (PCM) Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	-	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Are any other DTCs set?	-	Go to Diagnostic Trouble Code (DTC) List - Vehicle	Go to Step 3
3	Turn OFF the ignition for 15 seconds. Turn ON the ignition, with the engine OFF. Allow the pedal to rest at idle stop for 20 seconds. Observe the indicated throttle position parameter with a scan tool. Does the scan tool indicate throttle position within the specified values?	10.8-23.2%	Go to Step 6	Go to Step 4
4	Remove the throttle body assembly. Refer to Throttle Body Assembly Replacement . Did you find any obstructions preventing the throttle blade from returning to the default position?	-	Go to Step 5	Go to Step 6
5	Remove the obstruction. Did you complete the action?	-	Go to Step 7	-
6	Replace the throttle body assembly. Refer to Throttle Body Assembly Replacement . Did you complete the replacement?	-	Go to Step 7	-
7	Clear the DTCs with a scan tool. Turn OFF the ignition for 30 seconds. Start the engine. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records. Did the DTC fail this ignition?	-	Go to Step 2	Go to Step 8
8	Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed?	-	Go to Diagnostic Trouble Code (DTC) List - Vehicle	System OK