BPP Sensor Calibration
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
If the BCM, electronic brake control module (EBCM) or the brake apply sensor (BAS) is replaced a brake pedal position (BPP) sensor calibration must be preformed.
Perform the BPP Sensor Calibration using a scan tool if the BCM, EBCM or the brake apply sensing system (BASS) sensor has been replaced.
Using a scan tool preform the following:
- Navigate to the Module Setup menu in Computer Integrating Systems on the scan tool, select Body Control Module.
- Select BPP Sensor Calibration.
- Follow the on-screen directions.