Programming RKE Transmitters

IMPORTANT: All key fobs must be programmed each time any one fob is programmed.
The scan tool must stay connected until all of the transmitters are programmed.

Install a scan tool.
Turn ON the ignition with the engine OFF.
Select Remote Function Actuation.
Select Special Functions.
Select Program Key Fobs.
Select the number of key fobs to be programmed.
Press and hold the LOCK and the UNLOCK buttons simultaneously on the first transmitter for approximately 15 seconds. The Power Locks should cycle to confirm programming of the first fob is complete.
If you are programming more than one transmitter, repeat the previous step to program up to four transmitters.
Remove the scan tool.
Exit the vehicle. Attempt to lock/unlock the doors to verify the programming.
Operate the transmitter functions in order to verify correct system operation.