Crankshaft Main Bearing

Crankshaft Bearing Caps

Install the NEW crankshaft bearing bolts in sequence finger tight.
Tighten the crankshaft bearing bolts in sequence to 20 Nm (15 lb ft).

Tighten the crankshaft bearing bolts in sequence using the J 45059 - meter an additional 70 degrees.





Tighten the lower crankcase perimeter bolts in sequence to 25 Nm (18 lb ft).

Crankshaft Main Bearing Clearance 0.031-0.067 mm (0.0012-0.0026 in)