LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2009 >> Sky Red Line, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.0L - Introduction >> Repair Instructions >> Throttle Body Assembly Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Identifying ETC Connector
    GM1825527Courtesy of GENERAL MOTORS CORP.
    CAUTION: Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.
    Use care in cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as sharp tools may damage the gasket surfaces.
    CAUTION: Do not use any solvent that contains Methyl Ethyl Ketone (MEK). This solvent may damage fuel system components.
  1. Remove the charge air cooler outlet pipe. Refer to Charge Air Cooler Outlet Pipe Replacement .
  2. Disconnect the engine wiring harness electrical connector (1) from the electronic throttle control (ETC).
    3. Fig 2: Identifying Brake Booster Auxiliary Pump Connector
    GM1826929Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the engine wiring harness electrical connector (1) from the brake booster auxiliary pump.
  4. Remove the brake booster auxiliary pump electrical connector clip from the bracket.
    5. Fig 3: View Of Throttle Body & Bolts
    GM1769706Courtesy of GENERAL MOTORS CORP.
  5. Remove the throttle body bolts.
  6. Remove the throttle body and seal from the intake manifold.
scientia non olet · About LEMON Manuals