Electronic Brake Control Module Programming and Setup

Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed.

EBCM Reprogramming-Refer to Service Programming System (SPS) (Programming and Relearning).

EBCM Programming and Setup - Hybrid

If the electronic brake control module (EBCM) is replaced or needs reprogrammed, the following procedures must be performed:

* EBCM Reprogramming--Refer to Service Programming System (SPS) (Programming and Relearning).
* Perform the module setup EBCM Relearn.
* Perform the module setup Acceleration Sensor Reset.
* Perform the module setup BMC Prim. Piston Pos. Relearn.

Setup for Component Replacement

The replacement of ABS components such as the steering wheel position sensor may require a setup procedure for complete repair. Refer to Steering Angle Sensor Centering (Procedures)