LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2010 >> Sky Red Line, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 2.0L - Repair Instructions >> Repair Instructions >> Fuel Feed Pipe Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Identifying Fuel Feed Pipe & Bolts
    GM1825534Courtesy of GENERAL MOTORS CORP.
  1. Ensure that the fuel feed pipe and fuel pump fittings are clean prior to assembly.
  2. Lubricate the fuel feed pipe and the high pressure fuel pump fittings with silicon free engine oil GM P/N 12345610 (Canadian P/N 993193) or equivalent.
  3. Position the NEW fuel feed pipe onto the intake manifold.
  4. Install the fuel feed pipe fitting to the high pressure fuel pump hand tight.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the fuel feed pipe bolts.
    • Tighten the bolts to 10 N.m (89 lb in).
    • Tighten the fitting to 30 N.m (22 lb ft).
    6. Fig 2: Identifying EVAP & Fuel Feed Pipes
    GM1825535Courtesy of GENERAL MOTORS CORP.
  6. Connect the fuel feed line quick connect fitting (1) to the fuel feed pipe. Refer to Metal Collar Quick Connect Fitting Service .
  7. Inspect for leaks using the following procedure:
    1. Turn ON the ignition, with the engine OFF for 2 seconds.
    2. Turn OFF the ignition, for 10 seconds.
    3. Turn ON the ignition, with the engine OFF.
    4. Inspect for fuel leaks.
  8. Install the low side fuel pressure service port cap.
  9. Tighten the fuel fill cap.
scientia non olet · About LEMON Manuals