LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 2.0L - Repair Instructions >> Repair Instructions >> Engine Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Locating ECM
    GM1828317Courtesy of GENERAL MOTORS CORP.
  1. Connect the engine wiring harness electrical connectors (1, 3) to the ECM (2).
    2. Fig 2: Identifying Upper & Lower ECM Retaining Tabs
    GM1828318Courtesy of GENERAL MOTORS CORP.
  2. Slide the ECM into the bracket.
  3. Push down on the ECM until the upper and lower retaining tabs (1, 2) snaps into place.
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  5. Install the windshield washer solvent container. Refer to Windshield Washer Solvent Container Replacement (Solstice) or Windshield Washer Solvent Container Replacement (SKY) .
  6. Install the left front fender. Refer to Front Fender Replacement .
  7. Reset the clock and preset radio stations.
  8. If a NEW ECM was installed, the ECM must be programmed. Refer to Control Module References .
  9. If equipped with a manual transmission, perform the clutch pedal position sensor learn procedure. Refer to Clutch Pedal Position Sensor Learn .
scientia non olet · About LEMON Manuals