Inspection Procedure

1. Check that the power window manual UP/DOWN function operates normally.

NG: OTHER PROBLEM (See  MANUAL UP/DOWN FUNCTION DOES NOT OPERATE ON PASSENGER SIDE ONLY   ) 

OK: GO TO NEXT STEP 

1. Turn the ignition switch ON.
2. Operate the power window regulator switch.
3. Check the blinking pattern of the lamp as shown in Fig 2 .
   1. If pattern (1) or (3) is displayed, proceed to A.
   2. If pattern (2) is displayed, proceed to B.
   3. If the normal pattern is displayed, proceed to C.

Fig 1: Identifying Lamp Of Power Window Regulator Switch (Passenger Side)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: Blinking Pattern Of Lamp

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

B: Go to step   5 

A: GO TO NEXT STEP 

NG: Go to step 4 

OK: END 

1. Disconnect the P12 regulator switch connector.
2. Disconnect the P11 power window motor connector.
3. Measure the resistance of the wire harness side connectors.

   Standard: 

   POWER WINDOW REGULATOR MOTOR ASSY RH TERMINAL RESISTANCE
   
   

   Tester Connection	Specified Condition
   P12-5 (VCC) - P11-4 (SSRB)	Below 1 Ω
   P12-3 (PLS) - P11-5 PLS}	Below 1 Ω
   P12-4 (PLS2) - P11-3 (PLS2)	Below 1 Ω
   P12-8 (SGND} - P11-6 (E)	Below 1 Ω
   P12-5 (VCC) - Body ground	10 kΩ or higher
   P12-3 (PLS) - Body ground	10 kΩ or higher
   P12-4 (PLS2) - Body ground	10 kΩ or higher

   Fig 3: Measuring Resistance Of Wire Harness Side Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

OK: REPLACE POWER WINDOW REGULATOR MOTOR ASSY RH (PASSENGER SIDE)