Transmission Control Cable Assembly: Installation

INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
1. Put the cable into the body.
2. Install the No. 2 shift cable grommet retainer to the floor shift cable.
3. Install the floor shift cable as shown in the illustration.
  HINT:
  
  Securely engage the claws.
  
  Fig 1: Locating Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the No. 2 shift cable grommet retainer with the 2 bolts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 2: Locating No. 2 Shift Cable Grommet Retainer With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
1. Connect the cable to the control cable clamp.
  
  Fig 3: Identifying Control Cable Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the cable to the bracket with the clip.
  
  Fig 4: Locating Bracket With Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Temporarily install the cable to the control shaft lever with the nut.
INSTALL AIR CONDITIONING RADIATOR ASSEMBLY (See INSTALLATION )
INSTALL EXHAUST PIPE ASSEMBLY
1. Install exhaust pipe (see INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
INSPECT SHIFT LEVER POSITION (See ADJUSTMENT )
ADJUST SHIFT LEVER POSITION (See ADJUSTMENT )
INSTALL ENGINE UNDER COVER LH