Valve Body Assembly: Installation

1. Install the 5 shift solenoid valves with the 5 bolts and 3 plates.

   Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf) for bolt A 

   11 N*m (112 kgf*cm, 8 ft.*lbf) for bolt B 

   Bolt length: 

   12 mm (0.47 in.) for bolt A 

   45 mm (1.77 in.) for bolt B 

   Fig 1: Identifying Shift Solenoid Valves Plates And Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the spring and check ball body.
   Fig 2: Identifying Spring And Check Ball Body

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Align the groove of the manual valve with the pin of the lever.
4. Install the valve body with the 17 bolts.

   Torque: 11 N*m (110 kgf*cm, 8 ft.*lbf) 

   NOTE:

   • Push the valve body against the accumulator piston spring and the check ball body to install it.
   • First, temporarily tighten the bolts marked with a *1 in the illustration because they are positioning bolts.

     for bolt length:

     25 mm (0.984 in.) for bolt A

     41 mm (1.614 in.) for bolt B

     45 mm (1.771 in.) for bolt C

   Fig 3: Identifying Oil Stainer Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Coat a new O-ring with ATF.
2. Install the O-ring to the oil strainer.
   Fig 4: Locating Oil Strainer O-Ring

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the oil strainer with the 3 bolts.

   Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf) 

   Fig 5: Locating Oil Strainer Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Coat a new O-ring with ATF and install it to the ATF temperature sensor.
2. Install the ATF temperature sensor with the lock plate and bolt.

   Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf) 

3. Connect the 5 solenoid valve connectors.
   Fig 6: Identifying ATF Temperature Sensor With Lock Plate And Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the 2 magnets in the oil pan.
Fig 7: Identifying Oil Pan Magnets
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Apply seal packing or equivalent to the 18 bolts.

   Seal packing: 

   Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent 

   NOTE: Apply seal packing or equivalent to the bolts and tighten them within 10 minutes after application because the bolts should be seal bolts.
3. Install a new gasket and the oil pan to the transaxle case with the 18 bolts.

   Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf) 

Fig 8: Locating Oil Pan Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fluid type: Toyota Genuine ATF WS 

Standard capacity: 3.5 liters (3.7 US qts, 3.1 Imp. qts) 

1. Inspect the fluid (see AUTOMATIC TRANSAXLE FLUID  ).

1. Perform initialization (see INITIALIZATION ).
   NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.