LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Scion >> 2007 >> tC Base, Standard >> Repair and Diagnosis >> General Information >> Computer Relearn >> Engine Control System (2AZ-FE) >> IG2 Relay >> On-Vehicle Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

On-Vehicle Inspection

  1. REMOVE IG2 RELAY (Marking: IG2) 
    1. Remove the engine room relay block cover.
    2. Remove the IG2 relay from the engine room relay block.
  2. INSPECT IG2 RELAY 
    1. Measure the EFI relay resistance.

      Standard resistance 

      IG2 RELAY TESTER CONNECTION AND SPECIFIED CONDITION

      Tester Connection Specified Condition
      3-5 10 kΩ or higher
      3-5 Below 1 Ω (when battery voltage Is applied to terminals 1 and 2)

      If the result is not as specified, replace the relay.

  3. INSTALL IG2 RELAY 
    Fig 1: Identifying IG2 Relay Terminals
    G04869401Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals