Heated Oxygen Sensor: Installation

INSTALL HEATED OXYGEN SENSOR
1. Using SST, install the heated oxygen sensor onto the front exhaust pipe.
  SST 09224-00010
  
  Torque: without SST
  
  44 N*m (449 kgf*cm, 33 ft.*lbf)
  
  with SST
  
  40 N*m (408 kgf*cm, 30 ft.*lbf)
  NOTE:
  - This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.81 in.) and SST of 30 mm (1.18 in.) (See REPAIR INSTRUCTION ).
  - This torque value is effective when SST is parallel to the torque wrench.
    
    Fig 1: Installing Heated Oxygen Sensor
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Pass the sensor connector through the floor panel and install the grommet.
3. Install the wire harness clamp bracket.
  
  Fig 2: Locating Wire Harness Clamp Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the heated oxygen sensor connector.
INSPECT FOR EXHAUST GAS LEAK
INSTALL FRONT CONSOLE BOX (See INSTALLATION )
INSTALL REAR CONSOLE BOX SUB - ASSEMBLY (See INSTALLATION )
INSTALL CONSOLE BOX CARPET (See INSTALLATION )
INSTALL REAR CONSOLE BOX COVER (See INSTALLATION )
INSTALL UPPER CONSOLE PANEL (See INSTALLATION )
INSTALL SHIFT LEVER KNOB SUB - ASSEMBLY (for Manual Transaxle) (See INSTALLATION )