Throttle Body: Installation

INSTALL THROTTLE BODY ASSEMBLY
1. Install a new gasket onto the intake manifold.
  
  Fig 1: Locating Intake Manifold Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. install the throttle body assembly with the 2 bolts and 2 nuts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 2: Locating Throttle Body Assembly Bolts And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the water by-pass hose and the No. 2 water by-pass hose.
  
  Fig 3: Locating Water By-Pass Hoses
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the throttle body assembly connector.
INSTALL AIR CLEANER CAP SUB - ASSEMBLY WITH HOSE
1. Install air cleaner cap sub-assembly with hose and lock the 2 clamps.
2. Tighten the hose clamp to the specified torque.
  Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf)
  
  Fig 5: Locating Hose Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the No. 2 ventilation hose.
  
  Fig 6: Locating Ventilation Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the wire harness clamp and mass air flow meter connector.
ADD ENGINE COOLANT (See REPLACEMENT )
INSPECT FOR COOLANT LEAK (See ON-VEHICLE INSPECTION )
INSTALL NO. 2 CYLINDER HEAD COVER (See INSTALLATION )