Knock Sensor: Installation

INSTALL KNOCK SENSOR
1. Install the knock sensor with the bolt as shown in the illustration.
  Torque: 21 N*m (214 kgf*cm, 16 ft.*lbf)
  
  Fig 1: Installing Knock Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the knock sensor connector.
INSTALL INTAKE MANIFOLD
1. Install a new gasket onto the intake manifold.
2. Install the intake manifold and intake manifold stay with the 4 bolts and 2 nuts.
  Torque: 28 N*m (286 kgf*cm, 21 ft.*lbf)
  
  Fig 3: Locating Intake Manifold Bolts And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the water by-pass hose and the No. 2 water by-pass hose.
  
  Fig 4: Locating Water By-Pass Hoses
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the throttle body assembly connector.
  
  Fig 5: Locating Throttle Body Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the ventilation hose.
  
  Fig 6: Locating Ventilation Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Connect the 4 wire harness clamps.
INSTALL TRANSMISSION OIL LEVEL GAUGE SUB - ASSEMBLY (for Automatic Transaxle) (See INSTALLATION )
INSTALL OIL COOLER TUBE (for Automatic Transaxle) (See INSTALLATION )
INSTALL ENGINE OIL LEVEL DIPSTICK
INSTALL STARTER ASSEMBLY (See INSTALLATION )
INSTALL INJECTOR VIBRATION INSULATOR (See INSTALLATION )
INSTALL NO. 1 DELIVERY PIPE SPACER (See INSTALLATION )
INSTALL FUEL DELIVERY PIPE SUB - ASSEMBLY (See INSTALLATION )
CONNECT FUEL TUBE SUB - ASSEMBLY (See INSTALLATION )
INSTALL FUEL PIPE CLAMP (See INSTALLATION )
CONNECT VACUUM HOSE (See INSTALLATION )
CONNECT NO. 1 FUEL VAPOR FEED HOSE (See INSTALLATION )
INSTALL HARNESS BRACKET (See INSTALLATION )
INSTALL ENGINE WIRE HARNESS (See INSTALLATION )
INSTALL AIR CLEANER CAP SUB - ASSEMBLY WITH HOSE (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
ADD ENGINE COOLANT (See REPLACEMENT )
INSPECT FOR COOLANT LEAK (See ON-VEHICLE INSPECTION )
INSPECT FOR FUEL LEAK
(See PRECAUTION )
INSTALL NO. 2 CYLINDER HEAD COVER (See INSTALLATION )
INSTALL ENGINE UNDER COVER RH
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
INSTALL ENGINE UNDER COVER LH
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)