Inspection Procedure

1. Connect a Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the tester ON.
4. Clear DTC (See DTC CHECK / CLEAR  ).
5. Turn the ignition switch to OFF and turn the tester OFF.
6. Disconnect the tester.
7. Disconnect the cable from the battery negative (-) terminal and wait for 1 minute.
8. Connect the cable to the battery negative (-) terminal.
9. Connect the tester to the DLC3.
10. Turn the ignition switch to ON.
11. Turn the tester ON.
12. Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.
13. Read DTCs.

    Result 

    RESULT REFERENCE
    
    

    Result	Proceed to
    No output	A
    P060D	B

B : REPLACE ECM  (See REMOVAL  )

A : CHECK FOR INTERMITTENT PROBLEMS  (See CHECK FOR INTERMITTENT PROBLEMS  )