Confirmation Driving Pattern

HINT:

After a repair, check Monitor Status by performing the Key-Off Monitor Confirmation and Purge Flow Monitor Confirmation described below.

Key-off monitor confirmation
1. Preconditions
  The monitor will not run unless:
  - The vehicle has been driven for 10 minutes or more (in a city area or on a freeway)
  - The fuel tank is less than 90% full
  - The altitude is less than 8000 ft (2432 m)
  - The Engine Coolant Temperature (ECT) is between 4.4°C and 35°C (40°F and 95°F)
  - The Intake Air Temperature (IAT) is between 4.4°C and 35°C (40°F and 95°F)
  - The vehicle remains stationary (the vehicle speed is 0 km/h [0 mph])
2. Monitor Conditions
  1. Allow the engine to idle for at least 5 minutes.
  2. Turn the ignition switch to OFF and wait for 5 hours (7 or 9.5 hours).
    HINT:
    
    Do not start the engine until checking Monitor Status. If the engine is started, the steps described above must be repeated.
3. Monitor Status
  1. Connect a Techstream to the DLC3.
  2. Turn the ignition switch to ON.
  3. Turn the tester ON.
  4. Select the following menu items: Powertrain / Engine and ECT / Monitor / Evaporative System.
  5. Check the Monitor Status displayed on the tester.
    HINT:
    
    If Incomplete is displayed, the monitor is not completed. Make sure that the preconditions have been met, and perform the Monitor Conditions again.
Purge flow monitor confirmation (P0441)
HINT:

Perform this monitor confirmation after the Key-Off Monitor Confirmation shows Complete.
1. Preconditions
  The monitor will not run unless:
  - The vehicle has been driven for 10 minutes or more (in a city area or on a freeway)
  - The ECT is between 4.4°C and 35°C (40°F and 95°F)
  - The IAT is between 4.4°C and 35°C (40°F and 95°F)
2. Monitor Conditions
  1. Release the pressure from the fuel tank by removing and reinstalling the fuel cap.
  2. Warm the engine up until the ECT reaches more than 75°C (167°F).
  3. Increase the engine speed to 3000 rpm once.
  4. Allow the engine to idle and turn A/C ON for 1 minute.
3. Monitor Status
  1. Turn the ignition switch to OFF (if ON or the engine is running).
  2. Connect a Techstream to the DLC3.
  3. Turn the ignition switch to ON.
  4. Turn the tester ON.
  5. Select the following menu items: Powertrain / Engine and ECT / Monitor.
  6. Check the Monitor Status displayed on the tester.
    HINT:
    
    If Incomplete is displayed, the monitor is not completed. Make sure that the preconditions have been met, and perform the Monitor Conditions again.