Crankshaft Position Sensor: Installation

INSTALL CRANKSHAFT POSITION SENSOR
NOTE: Make sure that the O-ring is not cracked or jammed when installing.
1. Apply a light coat of engine oil to the O-ring of the sensor.
  
  Fig 1: Identifying O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the sensor with the bolt.
  Torque: 9.0 N*m (90 kgf*cm, 80 in.*lbf)
3. Install the wire harness clamp.
4. Install the connector clamp.
5. Connect the sensor connector.
6. Confirm that the wire harness of the sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.
INSTALL GENERATOR ASSEMBLY (See INSTALLATION )
INSTALL FAN AND GENERATOR V BELT (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 2: Identifying Wire Harness Clamp Bracket
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CHECK FOR ENGINE OIL LEAKAGE
INSTALL FRONT FENDER APRON SEAL RH (See INSTALLATION )
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.