Power Window Regulator Motor: Installation

INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY
1. Apply MP grease to the sliding and rotating areas of the regulator motor.
2. Using "TORX" socket wrench T25, install the power window regulator motor assembly front with the 3 screws.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 1: Locating & Installing 3 Power Window Regulator Motor Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY (See REASSEMBLY )
INSTALL REAR DOOR GLASS SUB-ASSEMBLY (See REASSEMBLY )
INSTALL REAR DOOR QUARTER WINDOW WEATHERSTRIP (See REASSEMBLY )
INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
1. Install the rear door window division bar with the 2 bolts and screw.
  Torque: 6.2 N*m (63 kgf*cm, 54 in.*lbf)
  
  Fig 2: Locating & Installing 2 Rear Door Window Division Bar Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the rear door weatherstrip.
Fig 3: Locating & Installing Rear Door Weatherstrip
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR DOOR GLASS RUN (See REASSEMBLY )
INSTALL REAR DOOR SERVICE HOLE COVER (See REASSEMBLY )
INSTALL REAR DOOR TRIM BRACKET (See REASSEMBLY )
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY (See REASSEMBLY )
INSTALL REAR DOOR INSIDE HANDLE BEZEL (See REASSEMBLY )
INSTALL REAR DOOR ARMREST BASE UPPER PANEL (See REASSEMBLY )
INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY
1. Apply MP grease to the sliding and rotating areas of the regulator motor.
2. Using "TORX" socket wrench T25, install the power window regulator motor assembly front with the 3 screws.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 4: Locating Power Window Regulator Motor Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (See REASSEMBLY )
INSTALL FRONT DOOR GLASS SUB-ASSEMBLY (See REASSEMBLY )
INSTALL FRONT DOOR SERVICE HOLE COVER (See REASSEMBLY )
INSTALL FRONT DOOR TRIM BRACKET (See REASSEMBLY )
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY (See REASSEMBLY )
INSTALL FRONT DOOR INSIDE HANDLE BEZEL (See REASSEMBLY )
INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH (See REASSEMBLY )
INSTALL FRONT ARMREST BASE UPPER PANEL (See REASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)