Data List / Active Test
- READ DATA LIST
HINT:
Using a Techstream to read the DATA LIST allows the values and states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.
NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.- Connect the Techstream to the DLC3.
- Turn the ignition switch ON and turn the tester ON.
- Enter the following menus: Body Electrical / Main Body / Data List.
- According to the display on the tester, read the "Data List".
Main Body:
MEASUREMENT ITEM/RANGE AND DIAGNOSTIC NOTETester Display Measurement Item/Range Normal Condition Diagnostic Note D Door Courtesy SW Driver side door courtesy light switch signal / ON or OFF ON Driver door open
OFF Driver door closed- P Door Courtesy SW Front passenger side door courtesy light switch signal / ON or OFF ON Front passenger door open
OFF Front passenger door closed- RR Door Courtesy SW Rear RH side door courtesy light switch signal / ON or OFF ON Rear RH side door open
OFF: Rear RH side door closed- RL Door Courtesy SW Rear LH side door courtesy light switch signal / ON or OFF ON Rear LH side door open
OFF. Rear LH side door closed-
- PERFORM ACTIVE TEST
HINT:
Using a Techstream to perform ACTIVE TESTs allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing ACTIVE TESTs early in troubleshooting is one way to save diagnostic time. DATA LIST information can be displayed while performing ACTIVE TESTs.
- Connect the Techstream to the DLC3.
- Turn the ignition switch ON and turn the tester ON.
- Enter the following menus: Body Electrical / Main Body / Active Test.
- According to the display on the tester, perform the "Active Test".
Main Body:
MEASUREMENT ITEM/RANGE AND DIAGNOSTIC NOTETester Display Test Part Control Range Diagnostic Note IG OFF P/W Control Permission Output Power window control permission output ON or OFF -