Automatic Transaxle Unit: Inspection: Inspection

INSPECT 2ND COAST AND OVERDRIVE BRAKE DISC
1. Check whether the sliding surfaces of the discs, plates and flanges are worn or burnt.
  
  Fig 1: Identifying Front Clutch Disc
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  If necessary, replace them.
  NOTE:
  - If the lining of any disc is peeling off or discolored, or even if a part of the printed number is defaced, replace all the discs.
  - Before assembling new discs, soak them in Toyota Genuine ATF WS or equivalent for at least 15 minutes.
INSPECT 2ND BRAKE DISC
1. Check whether the sliding surfaces of the discs, plates and flanges are worn or burnt.
  
  Fig 2: Identifying Front Clutch Disc
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  If necessary, replace them.
  NOTE:
  - If the lining of any disc is peeling off or discolored or even if a part of the printed mark is defaced, replace all the discs.
  - Before assembling new discs, soak them in Toyota Genuine ATF WS or equivalent for at least 15 minutes.
INSPECT 1ST AND REVERSE BRAKE DISC
1. Check to see if the sliding surfaces of the discs, plates and flanges are worn or burnt.
  
  Fig 3: Identifying 1st And Reverse Brake Disc
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  If necessary, replace them.
  NOTE:
  - If the lining of any disc is peeling off or discolored, or even if a part of the printed mark is defaced, replace all the discs.
  - Before assembling new discs, soak in Toyota Genuine ATF WS or equivalent for at least 15 minutes.
INSPECT 1ST AND REVERSE BRAKE RETURN SPRING SUB-ASSEMBLY
1. Using vernier calipers, measure the free length of the spring together with the spring seat.
  
  Fig 4: Measuring Free Length Of Spring Together With Spring Seat
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Standard free length
  
  13.96 mm (0.5496 in.)