Removal & Installation
WARNING: This page is about the xD Automatic Trans, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Includes: R&I Bumper Cover. Includes: R&I Radiator. Includes: R&I Subframe. DOES NOT include wheel alignment. | 10.7 | C | ||
| Combination Procedure: CLUTCH PRESSURE PLATE &/OR DISC: Remove & Replace: | ||||
| 0.3 | C | |||
| Combination Procedure: CLUTCH RELEASE BEARING: Remove & Replace: | ||||
| 0.2 | C | |||
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace: | ||||
| Rear | 0.7 | B | ||
| Combination Procedure: FLYWHEEL: Remove & Install or Remove & Replace: | ||||
| 0.5 | C | |||
| Combination Procedure: INPUT SHAFT SEAL: Remove & Replace: | ||||
| 2.1 | B | |||
| Combination Procedure: OUTPUT SEAL: Remove & Replace: | ||||
| Each | 0.2 | B | ||
| Combination Procedure: TRANSAXLE ASSEMBLY: Replace: | ||||
| 0.4 | C | |||