LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1982 >> GLF Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Ignition System >> NIPPONDENSO Electronic Ignition System >> Overhaul >> Reassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

NIPPONDENSO Electronic Ignition System: Overhaul: Reassembly

  1. Assemble in reverse order of disassembly, noting the following: Lightly grease signal rotor (reluctor) inner surface.
  2. Install on shaft aligning proper mark on stopper plate ("8" on Cressida; "10" on Corolla; "10.5" on Isuzu, LUV, and Land Cruiser; "11" on Subaru, Celica, and Corona; "12" on Pickup and Tercel; and "14" on Starlet.)
    NOTE: On Supra models, install distributor shaft so that stopper pin and governor shaft stopper pin are on same side. Install signal rotor on governor shaft with cutout portion of shaft positioned to right of governor stopper pin.
  3. When installing breaker plate, align 4 clips of plate with 4 grooves in housing.
  4. When replacing pinion, replace pin and pinion as a set. Adjust air gap between signal rotor and pick-up coil.
scientia non olet · About LEMON Manuals