LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1992 >> Justy Base >> Repair and Diagnosis >> Electrical >> Starter >> On-Vehicle Testing >> Circuit Test >> Manual Transmission
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Manual Transmission

  1. If voltage does not exist in any of the following circuit tests, check wiring for opens or shorts, or replace faulty component.
  2. Turn ignition switch to START position. Check for near battery voltage at ignition switch "S" terminal (Black/Yellow wire). If voltage exists, check for near battery voltage at both Black/Yellow wire terminals of starter interlock relay.
  3. Interlock relay has a Blue, 4-terminal connector and is located below EFC/MPFI control unit and to far left of unit. EFC/MPFI control unit is located behind drivers left dash panel.
  4. Clutch switch, located at top of clutch pedal arm, grounds interlock relays Black/Blue wire, energizing interlock relay. Press and hold clutch pedal to floor and check interlock relay's Black/White wire terminal for near battery voltage.
  5. If voltage exists, check for near battery voltage at starter solenoid "S" terminal (Black/White wire). If voltage exists at starter solenoid, start circuit is good. Problem is with starter.