3-Cylinder Ignition Timing: Justy

Warm engine to normal operating temperature. Place transmission in Neutral and turn off all accessories. Connect test mode connector. See Fig 1 .
Start engine and check timing marks located on crankshaft pulley. See 3-CYLINDER IGNITION TIMING SPECIFICATIONS table. If necessary, loosen distributor hold-down bolt and adjust ignition timing by rotating distributor. After adjusting ignition timing, tighten distributor hold-down bolt.

3-CYLINDER IGNITION TIMING SPECIFICATIONS

Application

⁽¹⁾ Degrees BTDC @ RPM

A/T

5 @ 800

M/T

5 @ 850

⁽¹⁾	With test mode connector connected

Fig 1: Locating Test Mode & Read Memory Connectors (Justy)

Courtesy of SUBARU OF AMERICA, INC.