LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1993 >> Impreza Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Code Testing >> Code 32: O2 Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 32: O2 Sensor

NOTE: Refer to illustration for ECU connector and terminal identification. See Figure .
  1. Turn ignition off. Disconnect ECU and O2 sensor connectors. Measure resistance between ECU connector E30, terminal No. 10 and O2 sensor connector terminal No. 4 (White wire). Zero ohms should be present. Measure resistance between O2 sensor connector terminal No. 4 (White wire) and ground. Minimum of one megohm should be present. If resistances are not to specification, repair or replace harness connector. If resistances are okay, go to next step.
  2. Reconnect O2 sensor connector. Start and run engine at idle. Disconnect O2 sensor connector. Measure voltage between O2 sensor connector terminal No. 4 (White wire) and ground. If voltage is fluctuating between .1 and 1.0 volt, repair ECU harness connector or replace ECU. If voltage is not fluctuating between .1 and 1.0 volt, replace O2 sensor.
scientia non olet · About LEMON Manuals