LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1993 >> Justy Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Code Testing >> Code 32: Oxygen Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 32: Oxygen Sensor

NOTE: Refer to illustration for ECU connector and terminal identification. See Figure .
  1. Start engine. With engine idling, measure voltage between ground and ECU connector F121, terminal No. 4 (backprobe). If voltage fluctuates between 0.1 and 1 volt, check for poor ECU connector contact. Repair connector and/or wiring harness as necessary. If voltage does not fluctuate between 0.1 and 1 volt, go to next step.
  2. Start engine. Ensure engine is at normal operating temperature. Disconnect oxygen sensor. Measure voltage between ground and oxygen sensor terminal. If voltage is about 0.5 volt, go to next step. If voltage is not about 0.5 volt, replace oxygen sensor.
  3. Disconnect ECU connectors. Measure resistance between ECU connector F121, terminal No. 4 and oxygen sensor connector (wiring harness side). If resistance is less than one ohm, check for poor ECU connector contact. Repair connector and/or wiring harness as necessary. If connector and wiring harness are okay, replace ECU. If resistance is more than one ohm, repair connector and/or wiring harness as necessary.
scientia non olet · About LEMON Manuals