LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1993 >> SVX >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Testing >> Fuel Pump Circuit Tests >> Legacy
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Pump Circuit Tests: Legacy

  1. Check Fuel Pump Operation In D-Check Mode  - Connect test mode connector and turn ignition on. Verify fuel pump operation for 2 seconds after turning ignition on. If fuel pump operates for 2 seconds, check fuel injector circuit. See LEGACY under FUEL INJECTOR CIRCUIT TESTS  . If fuel pump does not operate, go to next step.
  2. Check Fuel Pump Relay  - Disconnect fuel pump relay connector and remove fuel pump relay from bracket. Verify 70 ohms of resistance between fuel pump relay terminals No. 1 and 3. Replace fuel pump relay if resistance is not as specified. If resistance is okay, connect positive battery voltage to terminal No. 1 and negative lead to terminal No. 3. If fuel pump relay does not click, replace it. If fuel pump relay clicks, verify zero ohms resistance between terminals No. 2 and 4. If resistance is as specified, go to next step. If resistance is not as specified, replace fuel pump relay.
  3. Check Voltage Between Fuel Pump Relay & Ground  - Turn ignition off. Remove fuel pump relay without disconnecting connector. Verify at least 10 volts between fuel pump relay connector terminal No. 1 (Yellow wire) and ground. If at least 10 volts are present, go to next step. If at least 10 volts are not present, repair power harness or connector.
  4. Check Voltage Between ECU & Ground  - Turn ignition on. Verify at least 10 volts when ignition is on and zero volts while cranking engine. Measure voltage between ECU 26-pin connector terminal No. 23 (Light Green/Blue wire) and ground. If voltage is as specified, go to next step. If voltage is not as specified, repair faulty connector or ground circuit. If connector and ground are okay, replace ECU.
  5. Check Fuel Pump Terminal Voltage  - Remove fuel pump access cover located in trunk area and remove fuel pump connector. Verify at least 10 volts between 5-pin fuel pump connector terminal No. 1 (Brown wire) and ground. If at least 10 volts are present, go to next step. If at least 10 volts are not present, repair harness or connectors between fuel pump and fuel pump relay as necessary.
  6. Check Fuel Pump Operation  - Disconnect fuel pump connector. Connect battery positive voltage lead to terminal No. 1 and battery negative voltage lead to terminal No. 3. If fuel pump operates, repair fuel pump grounding circuit. If fuel pump does not operate, replace fuel pump.
scientia non olet · About LEMON Manuals