LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1993 >> SVX >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Code Testing >> Code 21: Coolant (Water) Temperature Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 21: Coolant (Water) Temperature Sensor

NOTE: Refer to illustration for ECU connector and terminal identification. See Figure .
  1. Remove collector cover and air intake boot. Disconnect coolant temperature sensor connector. Using an ohmmeter, check sensor resistance. Resistance should be 30,000 ohms at 68°F (20°C) and 400 ohms at 176°F (80°C). If resistance is as specified, go to next step. If resistance is not as specified, replace coolant temperature sensor.
  2. Turn ignition switch to OFF position. Disconnect ECU connectors. Check resistance between ECU connector B59, terminal No. 3 and sensor connector terminal No. 1 (Gray/Yellow wire), and between ECU connector B59, terminal No. 21 and sensor connector terminal No. 2 (Blue/Black wire)
  3. Resistance should be zero ohms for all circuits. If resistance is not as specified, repair appropriate circuit as necessary. If resistance is as specified, check ECU connector terminals for good contact. Repair as necessary. If connector terminals are okay, replace ECU.
scientia non olet · About LEMON Manuals