LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1993 >> SVX >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Code Testing >> Code 23: Airflow Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 23: Airflow Sensor

NOTE: Refer to illustration for ECU connector and terminal identification. See Figure .
  1. Check ECU input signal for airflow sensor. Turn ignition switch to ON position. Using a DVOM, check voltage between ECU connector B60, terminal No. 5 (backprobe) and ground. Voltage should be 0-0.3 volts. Check voltage between ECU connector B60, terminal No. 6 (backprobe) and ground. Voltage should not exist. Check voltage between ECU connector B59, terminal No. 11 (backprobe) and ground. Voltage should be 10-13 volts.
  2. With engine idling, check voltage between ECU connector B60, terminal No. 5 and ground. Voltage should be 0.8-1.2 volts. Check voltage between ECU connector B60, terminal No. 6 and ground. Voltage should not exist. Check voltage between ECU connector B59, terminal No. 11 and ground. Voltage should be 13-14 volts.
  3. If voltage is as specified in previous steps, check ECU connector terminals for good contact. Repair as necessary. If connector terminals are okay, replace ECU. If voltage is not as specified in previous steps, turn ignition switch to OFF position. Disconnect ECU and airflow sensor connectors.
  4. Using an ohmmeter, check resistance between ECU connector B59, terminal No. 11 and sensor connector terminal No. 3 (Black/Red wire), between ECU connector B60, terminal No. 4 and sensor connector terminal No. 1 (Red wire), between ECU connector B60, terminal No. 5 and sensor connector terminal No. 4 (White wire), and between ECU connector B60, terminal No. 6 and sensor connector terminal No. 2 (Black wire).
  5. Resistance should be zero ohms for all circuits. If resistance is not as specified, repair appropriate circuit as necessary. If resistance is as specified, replace airflow sensor.