LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1994 >> Impreza Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Code Testing >> Code 35 - Purge Control Solenoid Valve
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 35 - Purge Control Solenoid Valve

NOTE: Refer to illustration for ECU connector and terminal identification. See Figure -Figure .
  1. Turn ignition on. Measure voltage between ECU connector E30, terminal No. 19 (backprobe) and ground. If voltage is 10-13 volts, repair ECU harness connector or replace ECU. If voltage is not 10-13 volts, go to next step.
  2. Turn ignition off. Disconnect purge control solenoid valve. Measure resistance between solenoid valve terminals. Resistance should be 36 ohms at 68°F (20°C). If resistance is not to specification, replace purge control solenoid valve. If resistance is to specification, go to next step.
  3. Turn ignition on. Measure voltage between purge control solenoid valve connector terminal No. 1 (Yellow/Red wire) and ground. If about 10 volts are present, repair or replace harness connector between ECU and purge control solenoid valve. If about 10 volts are not present, repair or replace power supply circuit.
scientia non olet · About LEMON Manuals