LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1994 >> Legacy Alpine >> Repair and Diagnosis >> Electrical >> Starter >> On-Vehicle Testing >> Ignition Switch Test >> Start Circuit Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Start Circuit Test

  1. Remove lower instrument panel below steering wheel. Remove air duct. Disconnect ignition switch harness connector.
  2. Using jumper wire, apply 12 volts to ignition switch terminal "B". See Figure . Connect test light to switch terminal "S". Turn ignition switch to START position. If test light does not illuminate, replace relay.
scientia non olet · About LEMON Manuals